Cam Syva

Product Definition
> Acrylic emulsion based, trowel applied, coarse, ready mixed, interior and exterior plaster containing glass particles.

Application Areas
> On new exterior mineral surfaces such as concrete, mortar, cement panel, etc., on previously painted surfaces and on wooden, porous glass and porous plastic panels.

Features
> Long lasting
> High water vapour permeability
> Alkali resistant
> Water resistant.
> Transparent and available in 22 colours.

Technical Features
> DRYING TIME: (at 23˚C and 50 % RH) Surface dry after 24 hours and thoroughly dry after 2-3 days. Lower temperatures or higher relative humidity will lengthen the drying process.
> CONSUMPTION: On smooth surfaces approximately 4.0 - 5.0 kg/m2

Application Instructions
> The substrate must be cleaned from dust, dirt, oil and old blistered coatings that may prevent good adhesion. The surface should be made sound, clean and dry. All water insulation precautions should have been taken prior to application.
> The surface on which CAMSIVA will be applied should be previously primed with Kalecolor SYLASTAR or Kalecolor ÜNY-ASTAR in the same color shade of the plaster.
> CAMSIVA should be mixed thoroughly before application until it is homogeneous.
> After the primer has dried, CAMSIVA should be spread evenly on the surface in the thickness of mosaic particles using a stainless steel trowel.
PLEASE NOTE:
> The ambient and substrate temperature should be above +5˚C and the surface should be rain and snow free during application and during the 24 hours following the application. • Application should not be made in extremely hot weather, under glaring sun, during strong wind, fog, high relative humidity, imminent rain or frost.
> Hot surfaces should be dampened before application.
> In order to avoid differences in shades of color care should be taken to use products with the same batch number. In the event products with different batch numbers are to be used, the entire required amount should be mixed prior to application.
> In order to avoid overlapping in large areas or after work pauses, masking tape should be used or an adequate number of applicators should be employed to apply the plaster wet-on-wet without interruptions.

Warnings
> S 2 Keep out of the reach of children.
> S 24/25 Avoid contact with skin and eyes.
> S 46 If swallowed, seek medical advice.

Storage
> Store between 5-35˚C in its unopened pail.

Back

Top

Print